Warranty conditions

In Addition to any statutory rights resulting from the purchase, this product is covered by a waranty as stated below.

1. The warranty period is 12 months and commences on the date when the product was purchased. This date has to be documented by an invoice or other proof of purchase.The warranty period is one year minimum for products, and one year for batteries and chargers. This warranty applies only on new products.

2. There is a possibility to extend the warranty period over the period described above using the registration on the www.milwaukeetool.eu website. The end user needs to register his/her newly-acquired tools online within 30 days the date of purchase. The end user may register for the extended warranty in his country of residence if listed on the online registration form where this option is valid. Furthermore, end users must give their consent to the storage of the data which are required to enter online and they have to accept the terms and conditions.The registration certificates, which is sent out by e-mail, and the original invoice or other proof of purchase (receipt) showing the product and date of purchase will serve as proof of the extended warranty. Your statutory rights remain unaffected.

3. The warranty covers all defects of the product during the warranty period due to defaults in workmanship or material at the purchase date. The warranty is limited to repair and/or replacement and does not include any other obligations including but not limited to incidental or consequential damages. The warranty is not valid if the product has been misused, used contrary to the instruction manual, or being incorrectly connected. This waranty does not apply to:
any damage to the product that is the result of improper maintenance
any product that has been altered or modified
any product where original identification (trade mark, serial number) markings have been defaced, altered or removed
any damage caused by non-observance of the instruction manual
any non CE product
any product which has been attempted to be repaired by an non-qualified professional or without prior authorization by Techtronic Industries
any product connected to improper power supply (amps, voltage, frequency)
any damage caused by external influences (water, chemical, physical, shocks) or foreign substances
normal wear and tear of spare parts
inappropriate use, overloading of the tool
use of non-approved accessories or parts
Power tool accessories provided with the tool or purchased separately. Such exclusions including but not limited to screw driver bits, drill bits, abrasive discs, sand paper and blades, lateral guide
Components (parts and accessories) subject to natural and normal wear and tear, including but not limited to Service & Maintenance Kits, carbon brushes, bearings, chuck, SDS drill bit attachment or reception, power cord, auxiliary handle, transport carry case, sanding plate, dust bag, dust exhaust tube, impact Wrench Pins & springs, drive Belts, felt Washers, Hitch Pins, Vacuum Bag , Hoses, Connector fittings, Wheels, fix-tech adaptors, bump knobs, drive belts, clutches, blades of brush cutters, hedge trimmers or lawn mowers, harnesses, cable throttle, tines, felt washers, hitch pins, blower fans, blower and vacuum tubes or nozzles, blower vacuum bags and straps, guide bars, saw chains, hoses, connector fittings, spray nozzles, wheels, spray wands, inner reels, outer spools, cutting lines, vacuum mulching blades, etc.

4. For servicing, the product must be sent or presented to a Milwaukee authorized service station listed for each country in the following list of service station addresses. In some countries your local Milwaukee dealer undertakes to send the product to the Milwaukee service organization. When sending a product to an Milwaukee service station, the product should be safely packed without any dangerous contents, marked with sender’s address and accompanied by a short description of the fault.

5. A repair/replacement under this warranty is free of charge. It does not constitute an extension or a new start of the warranty period. Exchanged parts or tools become our property. In some countries delivery charges or postage will have to be paid by the sender.

6. This warranty is valid in the European Community, Switzerland, Iceland, Norway, Liechtenstein, Turkey and Russia. Outside these areas, please contact your authorized dealer to determine if another warranty applies.